WiNG Controller v7.9.5.1 NOVA Getting Started Guide

Choose from the following actions:

If you are in the process of configuring a new Wireless Client Roles policy, proceed to the next step.
If you want to edit LDAP Settings for an existing policy, go to Policies > Wireless Client Roles, then select adjacent to the target policy. Proceed to the next step.

Under the General pane, configure the LDAP parameters as described in General LDAP Parameters.

Table 1. General LDAP Parameters
Parameter	Description
LDAP Query	Select to enable LDAP Query service for this Wireless Client Roles policy, then use the drop-down menu to select an LDAP query mode. Options include: Internal (Self) － Select Internal (Self) to use local LDAP server resources configured under the LDAP Server Options pane. Through Wireless Controller － If this option is selected, the AP queries the LDAP server for user information through the controller. Use this option when the AP is Layer 2 adopted to the controller.
Dead Period	Select the Dead Period in the range 60–300 seconds. The LDAP dead period is the interval between two consecutive attempts to bind with the LDAP server.
Timeout	Select a Timeout value in the range 1–5 seconds to specify the allowable delay between a request sent to and response from the LDAP server before LDAP bind and queries will be timed out.

Under the LDAP Server Options pane, you can modify settings of an existing LDAP server, or select Add to add a maximum of two LDAP servers to the list.

Configure the parameters as described in LDAP Server Options Parameters.

Table 2. LDAP Server Options Parameters
Parameter	Description
Server ID	Enter the LDAP server ID as either 1 or 2.
Host	Enter the LDAP server's fully qualified domain name or IP address in the Host field.
Bind DN	Enter the LDAP server's bind distinguished name.
Base DN	Enter the LDAP server's base distinguished name.
Bind Password	Enter the password for bind. Select to display the password.
Port	Enter the LDAP server port number. Select a port number in the range 1–65535.
Action	Select to delete an LDAP server entry.

After you have completed configuring the settings, choose from the following actions:

Select Revert to restore default settings or restore the last saved settings.

Note
You cannot restore default settings after applying or saving changes.
Select Apply to commit the configured settings.

Note
This does not permanently save the settings you configured. If you perform a Reload (warm reboot), applied settings will be lost.
Select Save to commit and save the configured settings.

Note

If you do not select Apply or Save, the settings that you configured are not saved when you move away from the configuration window.

Configure LDAP SettingsNEW!